PDA

View Full Version : Downloading to HellFire Remote not happening


dundeedoogeroo
02-09-2013, 12:15 PM
Hi, The FOXPRO Programmer indicates the new list of calls is there, and the download to the remote shows the bar filling from left to right, indicating it was successful. After this the remote screen says to unplug the cable, the sound list that appears has not been updated. The cable has been successfully used for loading in the past, so any ideas as to why the download is not successful this time? Best Regards.

FPScott
02-09-2013, 06:16 PM
If the sound list on the remote control is not changing at all then the first thing to try would be a second cable.

Jingles
02-09-2013, 08:47 PM
If the hellfire is like the Firestorm you have to press the send button for a few seconds after the transfer

dundeedoogeroo
03-05-2013, 03:23 PM
Thanks guys - though none of these tricks are successful. I converted the new sounds to mp3 in a higher than the standard (128?) bitrate. Would this make them non-compatible with the FOXPRO?