PDA

View Full Version : tx9 remote update call list


gvolk
10-10-2012, 07:20 PM
I loaded new sounds to my firestorm today. I then followed instructions on how to update the call list on the remote. The farthest I get on the remote is it tells me to turn caller on. when I turn the caller on nothing happens the message doesn't change and that message just sits there. Any suggestions??

gvolk
10-10-2012, 07:43 PM
after I have plugged in the cable to aux and then turn remote on it doesn't seem like it recognizes caller. until I disconnect cable from caller then it says turn on call to begin transfer. sounds backwards to me.

I have a coyote tournament on saturday so if anyone has an idea on what to do I would really appreciate it.

FPScott
10-11-2012, 08:28 AM
Verify that the cable you are using is a stereo cable and not a mono one. Stereo cables will have three segments divided by two black rings on each end.
If you are using the proper cable I would recommend trying a second cable as this does sound like a cabling issue.

gvolk
10-12-2012, 01:46 PM
it turned out the cable was bad that came with the caller.
all is good after I bought a new one.

Thanks for the suggestion.